Poppy Coat Sew Along

4 Back Together Square

4 — Sew the Lining

Posted
01—July 2021

We will now assemble your lining, facings and collar!

Poppy Coat Sew Along — 4 — Sew the Lining, Facings and Collar
Jul 1 2021
1 Pin Lining Backs
Lining

With the right sides together, pin the two back lining pieces together. Sew the seam at 1cm. Press your seam as sewn.

3 Lining Stress Stitch
4 Back Together

At the centre back neck notch, sew down 2cm parallel to the centre back seam.

Press the seam to one side and then baste the excess at the neckline edge, to create a pleat in the lining.

6 Pin Lining Sleeve Togther
7 Lining Sleeve

With the right sides together, pin the front sleeve lining to the back sleeve lining along the upper edge. Sew the seam at 1cm.

Repeat for the other sleeve. Press the seams open.

8 Pin Lining Sleeve To Lining Back

Pin the back sleeve lining to the back lining with the right sides together and matching the notches. Sew at 1cm.

9 Pin Lining Sleeve To Lining Front
10 Lining Sleeves Attached

Now pin the front sleeve lining to the front lining, right sides together and matching the notches. Sew at 1cm.

Repeat for the other side then press all four seams open.

11 Pin Lining Side Seams
14 Sew Lining Side Seams Leave Space

With the right sides together, pin the front lining to the back lining at the side seam. Match the notches and the seams. Sew the side seam at 1cm.

Repeat for the other side, leaving an opening of 20-30cm in the sleeve for turning your coat out at the end. Press the seams open.

12 Facing Stress Stitch
Facings

We will now sew the facings. At each corner on the front facing at the neckline, sew a line of stitching 1cm from the edge to reinforce corners where collar turns on fronts. Clip into the corner to release the seam allowance. This will allow you to manoeuvre the pieces when sewing the collar.

13 Pin Facing
15 Facings Togther

Pin the front facing to the back neck facing at the shoulder. Sew with a 1cm seam and then press the seams open.

22 Attaching Facings

Pin the facing to the lining with the right sides together and matching the notches and seams.

Starting at the notch halfway down one front, sew the lining and facing together with a 1cm seam, finishing at the notch on the other front. The lower edges of the lining and facing will be finished later.

Press the seam towards to lining.

17 Matching Notches
18 Collar Stand Is Pinned
Collar

Now we will sew the collar.

With the right sides together, pin the top collar to the collar stand, matching the notches.

Sew the top collar and collar stand together. Take care not to create any tucks.

19 Snip Into Seam Allowance
20 Press Seam Allowance

Clip into the top collar seam allowance and then press the seam open.

23 Pinning Collar To Facing
24 Matching Stress Point

With the right sides together, pin the top collar to the facing.

25 Matching Notches
26 Pinned Collar

As you did with the under collar, start at the notch at one end of the top collar and sew the two pieces together with a 1cm seam. When you reach a corner, stop with your needle down and raise the presser foot. Pivot your coat and continue sewing to the next corner. Stop with your needle down once again. Pivot your coat once more and continue to the end of the top collar.

28 Lining Complete

Press the seam open. It's now time to attach the lining to your coat!

Check out the Poppy Coat pattern in our Online Store here. Don't forget you can always email us via [email protected] if you need advice!

Poppy makes from our wonderful community are also popping up over on Instagram, follow @makebytfs and use #TFSPoppyCoat so others can check out your creations!

© the Fabric Store
Location — Australia